MEng – Manufacturing Engineering: Discrete Manufacturing Course Selection form

Instructions for completing this form:

1. For the following program requirements, please select all courses that you are intending to take for your program, including courses that you have not yet enrolled in on Mosaic.
2. At the end of the course selection, you should have selected courses adding up to 30 units.
3. Once you select your desired course, the terms that the selected course is projected to be available will appear under the heading “Term to be taken”.
• If you are unsure about courses in the future, the current course timetable can be used as a guide for when each course will be offered in the academic year.
  Please note: we cannot guarantee that a course will be offered each year. Please estimate the term that you will be taking that course.
4. Complete the form as though you are completing the Course-based pathway and will not be taking co-op.
   • Projects and co-ops are optional parts of the program and not guaranteed, therefore please do not take them into consideration when selecting your courses for this form.

Important: There are no breaks in the programs. Please enroll in every term.

The two project courses are:

Note: Do not enroll in the project courses until your project has been confirmed by Salman Bawa. More information on the projects will be sent to you by Salman Bawa.

Note: Projects must be completed before a student may go on co-op.

Please do not enroll in the project courses at this time.

More information on the projects will be discussed during the first term, around mid-term.

If you have already enrolled in these courses, please login to Mosaic and drop them as soon as possible.

All students in the Manufacturing Engineering program are required to take 2-3 Professional Development courses. 3 courses in this category is the maximum number permitted.

Choose 2-3 courses from the following:

Note: Additional elective course options can be found in your Course Registration Document

Note: If a course is worth 1.5 units, please add them on separate lines

If you do not wish to take one of the recommended technical electives, please choose “No Selection”, and add your selected courses in “Other Technical Electives” area.

Additional Technical Elective options can be found in your Academic Calendar. If you would like to take any of these courses, please list them below as they may require an In-program adjustment form for approval to have the course counted towards your program requirements. Your graduate administrative assistant will contact you if this form is required.

Co-op is an optional part of the program. It is not mandatory.

Units associated with the Co-op “courses” do not count towards your 30-unit program requirements.

Please note:

1. If you are taking a project, you cannot go on co-op until after the project is completed.
2. You must hold one course back to complete after the co-op. You must return to your studies for one term after co-op as a student only. You cannot complete your studies and your co-op at the same time.