Dr. Mostafa Soliman, P.Eng.

3 unit(s)

Introduction to electronic circuits; DC and AC sources, resistors, inductors, and capacitors; phasors and impedance; transient and steady-state analysis; network analysis; energy and power.

Four lectures, one lab (three hours); second term

Prerequisite(s): Registration in Automation Engineering Technology, or Automotive and Vehicle Engineering Technology, or Biotechnology

3 unit(s)
Outline the design, installation and commissioning of Bio-Mass, Fuel-Cells and Geothermal powered systems. The environmental and economical impacts of such technologies. Federal and provincial rules, regulations, and legislation.

Three lectures; one term

Prerequisite(s): ENRTECH 3EP3, 3TD3, ENGTECH 4TF3 and registration in Power and Energy Engineering Technology

3 unit(s)
Design, installation and commissioning of Solar, Wind and Hydro power plants. The environmental and economical impacts of such technologies, rules, regulations, federal and provincial legislation.

Three lectures; one term

Prerequisite(s): ENRTECH 3EP3, 3TD3, ENGTECH 4TF3 and registration in Power and Energy Engineering Technology

3 unit(s)
This course covers analysis and design of closed loop control systems. System characteristics and performance, stability analysis, system types, performance improvement, digital control systems, compensation, filtering and motion system tuning.
Three lectures, one lab (three hours); first term

Prerequisite(s): ENGTECH 2MT3, PROCTECH 2IC3, 2PL3 and registration in level III or above of Process Automation Technology.

3 unit(s)
This first level SCADA course covers the following topics: introduction to SCADA, digital conversion theory, sensors and detectors, noise and filtering, communication protocols, databases and process control evaluation.
Three lectures, one lab (three hours); first term

Prerequisite(s): ENGTECH 1PR3, PROCTECH 2EE3, 2IC3 and registration in level III or above of Process Automation Technology.

1 unit(s)
This course requires students to research, design, develop and implement an independent project. The project plan and a model developed will be documented as a technical report and presented in a seminar.
One tutorial, one lab (two hours); second term

Prerequisite(s): PROCTECH 3CE3, 3MC3, 3SD3, GENTECH 3MT3 and registration in level IV of Process Automation Technology.

3 unit(s)
This course is a continuation of Technical Project I and it requires students to conduct further research, modify/refine project design, develop and implement the independent project proposal submitted as a part of the Technical Project I course. The project will be documented as a technical report and presented in a seminar.
One tutorial, one lab (three hours); first term

Prerequisite(s): PROCTECH 4TR1, 4IC3, 4IT3; ENGTECH 4EE0 and registration in level IV of Process Automation Technology.

Co-requisite(s): PROCTECH 4SS3